Error Codes

Breville/Sage error code ER05 — how to fix it

Error codes on Breville Sage machines usually point to a specific condition: a full drip tray, an empty water tank, a stuck brew unit, or scale buildup. The most common codes are listed in our error code flashing guide — most are cleared by a power reset or a descaling cycle.

Power & Startup

Breville Barista Touch won't turn on

When a Breville Sage machine won't turn on, check the outlet, the power cord, and the switch first. Unplug it for 60 seconds and retry — this clears most temporary control-board faults. If it stays dead, the thermal fuse or power supply may need replacing; see our not turning on guide.

Breville Bambino problems: what to check

When a Breville Sage machine won't turn on, check the outlet, the power cord, and the switch first. Unplug it for 60 seconds and retry — this clears most temporary control-board faults. If it stays dead, the thermal fuse or power supply may need replacing; see our not turning on guide.

Descaling & Maintenance

Can I descale a Breville/Sage machine with vinegar?

Scale builds up inside every coffee machine and eventually blocks the boiler and pipes. Run a full descaling cycle with Breville Sage's approved descalant every 2-3 months (or whenever the machine prompts it), then rinse with fresh water. If your machine refuses to descale, see our not heating guide.

Water Leaks

Breville espresso machine leaking — common causes

Water leaking from a Breville Sage machine is usually a loose hose, a worn seal, or a drip tray that is not seated correctly. Dry the machine and trace where the water appears during a brew cycle — most leaks are repairable without a service visit. Full steps in our leaking water guide.

Grinder Problems

Breville coffee machine grinder not working

A Breville Sage grinder that stops usually has beans jammed in the burrs, an empty-hopper sensor triggered, or worn burrs. Empty and brush the hopper, run a few dry beans through, and never force the motor. Detailed steps in our grinder not working guide.

Water Flow & Pumping

Breville machine water not working

If no water comes out of your Breville Sage machine, the tank may be mis-seated, there may be air in the circuit, or the pump inlet is blocked by scale. Reseat the tank, run a blank cycle to purge air, and descale if flow stays weak. See our water not pumping guide.

Milk Frothing & Steam

Sage coffee machine not frothing milk

Weak or missing froth on a Breville Sage usually means a dirty steam wand, wet steam, or milk that is too warm. Purge the wand, clean the nozzle air hole, and use cold whole milk with the tip just below the surface. More in our no froth guide.